10 1 
Home Page  

  • SciELO

  • Google
  • SciELO
  • Google


Earth Sciences Research Journal

 ISSN 1794-6190

TAVERA, Hernando; VILCA, Renzo    MARIN, Gloria. INFERENCES ON THE GEOMETRY OF THE NAZCA PLATE IN NORTHWESTERN PERÚ BASED ON DATA COLLECTED BY A LOCAL SEISMOGRAPH NETWORK. []. , 10, 1, pp.15-24. ISSN 1794-6190.

^len^aIn Central and Southern Peru, local and teleseismic data allow having insights on the Wadati-Benioff zone (WBZ) geometry. In the region of Northern Perú, only rough estimates of the WBZ geometry have been proposed, and were obtained using teleseismic data due to the reduced number of mb≥4.0-magnitude earthquakes available. The installation of a local seismic network in the NW border of Northern Perú, allowed the recording of a large number of earthquakes with magnitudes ranging from 1.8 to 4.1 ML, and maximum depths of 120 km., distributed over the area where the occurrence of earthquakes with magnitudes > 4.0 is scarce. In a vertical section, oriented N70˚E earthquakes are distributed along a 10° dipping plane from the trench. Landwards from the coastline, the dip angle increases to 28°. These results allow a high resolution definition of the Nazca plate geometry in NW Perú. Focal mechanisms computed for 22 earthquakes located between 50 and 120 km depth beneath the network suggest the development of deformation processes in direction parallel to the convergence Nazca plate direction.^les^aEn la región centro y sur de Perú, la geometría de la Zona Wadati-Benioff (ZWB) ha sido estudiada con el uso de datos locales y telesísmicos; mientras que, para la región norte, solo se han realizado análisis utilizando datos telesísmicos debido al escaso número de sismos con magnitudes mb≥4.0. La instalación de una red sismográfica en el borde NW de la región norte de Perú, ha permitido detectar un importante número de sismos con magnitudes ML entre 1.8 y 4.1, y profundidades máximas hasta 120 km, todos distribuidos sobre el área en donde la ocurrencia de sismos con magnitudes ML mayores a 4.0 es mínima. En una sección vertical orientada N70°E, los sismos se distribuyen en profundidad, desde la fosa siguiendo una pendiente de 10° y a partir de la línea de costa hacia el continente, el ángulo de inclinación aumenta a 28°. Estos resultados permiten definir con alta resolución la geometría de la placa de Nazca en el borde NW de la región norte de Perú. Los mecanismos focales calculados para 22 sismos ubicados por debajo de la red entre 50 y 120 km de profundidad, sugieren el desarrollo de diversos procesos de acomodación de movimiento en dirección paralela a la dirección convergencia de la placa de Nazca.

: .

        · | |     · |     · ( pdf )

 

Creative Commons License All the contents of this journal, except where otherwise noted, is licensed under a Creative Commons Attribution License